• Hey All! Lately there has been more and more scammers on the forum board. They register and replies to members requests for guns and/or parts or other things. The reply contains a gmail or hotmail address or similar ”anonymous” email addresses which they want you to reply to. DO NOT ANSWER ANY STRANGE MESSAGES! They often state something like this: ”Hello! Saw your post about purchasing a stock for a Safari. KnuckleheadBob has one. Email him at: [email protected]” If you receive any strange messages: Check the status of whoever message you. If they have no posts and signed up the same day or very recently, stay away. Same goes for other members they might refer to. Check them too and if they are long standing members, PM them and ask if the message is legit. Most likely it’s not. Then use the report function in each message or post so I can kick them out! Beware of anything that might seem fishy! And again, for all of you who registered your personal name as username, please contact me so I can change it to a more anonymous username. You’d be surprised of how much one can find out about a person from just a username on a forum such ad our! All the best! And be safe! Jim

A pair of L461 Single Shot Sako Benchrest Rifles

Sako Collectors Club Discussion Forum

219Zipper

Member
I'm new here, I hope I am performing the requirements properly . . .

The rifle in the rear ground is chambered in 22 PPC, I purchased it new in September of 1989. The rifle in the fore ground is chambered in 6mm PPC, I bought it last week. Both rifles shoot extremely precise results at the range - barely believable results, in fact.
 

Attachments

  • IMG_0906.JPG
    IMG_0906.JPG
    161.5 KB · Views: 45
  • IMG_0907.JPG
    IMG_0907.JPG
    157.1 KB · Views: 44
  • IMG_0908.JPG
    IMG_0908.JPG
    166.3 KB · Views: 43
We're always glad to see photos of Sako, Zipper.

Yes, the Sako PPC's are probably on average the most accurate rifles you can buy off-of-the-shelf. Dedicated benchrest shooters spend thousands of dollars on barrels, gunsmithing, special reloading equipment and countless hours on things like neck-turning and sorting brass and bullets in order to improve by a tiny fraction of an inch on what your PPC's will do.
 

Latest posts

Back
Top