TRG Stock Riser Spacer

Discussion in 'Sako TRGs' started by BSP, Sep 3, 2020.

  1. BSP

    BSP Member

    Messages:
    1
    Likes Received:
    0
    Country Flag:
    USA
    State/Region:
    US California
    Hi All,


    Having looked at the factory cheek riser spacer, I was disappointed in the crude solution Sako offered, so I designed and built my own as a 3D printed part. See attached photos. It fits the contours of the stock closely. I confirmed chemical resistance of the plastic over time against Hoppes #9. I can make in 5mm, 10mm and 15mm options.

    Any interest?

    Regards,

    Bryan
     

    Attached Files:


Share This Page

This site uses cookies. By continuing to use this site, you are agreeing to our use of cookies. Okay More information