• Hey All! Lately there has been more and more scammers on the forum board. They register and replies to members requests for guns and/or parts or other things. The reply contains a gmail or hotmail address or similar ”anonymous” email addresses which they want you to reply to. DO NOT ANSWER ANY STRANGE MESSAGES! They often state something like this: ”Hello! Saw your post about purchasing a stock for a Safari. KnuckleheadBob has one. Email him at: [email protected]” If you receive any strange messages: Check the status of whoever message you. If they have no posts and signed up the same day or very recently, stay away. Same goes for other members they might refer to. Check them too and if they are long standing members, PM them and ask if the message is legit. Most likely it’s not. Then use the report function in each message or post so I can kick them out! Beware of anything that might seem fishy! And again, for all of you who registered your personal name as username, please contact me so I can change it to a more anonymous username. You’d be surprised of how much one can find out about a person from just a username on a forum such ad our! All the best! And be safe! Jim

TRG-s/M995 bolt stop pin thread

Sako Collectors Club Discussion Forum

zaitsev

Member
To cut a very long story short: I have a Trg-s that had all the fixings loctited in. I had to mill the bolt stop pin out and now need to chase the threads. What size/pitch are the threads please? By the stamp on the stock the rifle is a ‘94 model.

Thanks in advance

G
 
The thread is M3. The same bolt stop parts go in all TRG models with the exception of TRG M10.
 
Thanks very much for the response. Would I be right in thinking that it is M3x 0.5 rather than the finer M3x 0.35?

Thanks

G
 
Back
Top