• Hey All! Lately there has been more and more scammers on the forum board. They register and replies to members requests for guns and/or parts or other things. The reply contains a gmail or hotmail address or similar ”anonymous” email addresses which they want you to reply to. DO NOT ANSWER ANY STRANGE MESSAGES! They often state something like this: ”Hello! Saw your post about purchasing a stock for a Safari. KnuckleheadBob has one. Email him at: [email protected]” If you receive any strange messages: Check the status of whoever message you. If they have no posts and signed up the same day or very recently, stay away. Same goes for other members they might refer to. Check them too and if they are long standing members, PM them and ask if the message is legit. Most likely it’s not. Then use the report function in each message or post so I can kick them out! Beware of anything that might seem fishy! And again, for all of you who registered your personal name as username, please contact me so I can change it to a more anonymous username. You’d be surprised of how much one can find out about a person from just a username on a forum such ad our! All the best! And be safe! Jim

Sako Factory Barrels

Sako Collectors Club Discussion Forum

emmerth

Well-Known Member
Hi everyone, it has been awhile. I have some items that I will be listing here first to the club. I have 6 Sako factory barrels. They all appear to be in very good condition and the inside of barrels are clean. All have some storage marks but unless noted below, are minimal. I would like to sell as a lot for simplistic reasons so I am offer all 6 shipped CONUS for $200.00. Otherwise, I am asking $80.00 each. Or make offer. All measurements for the barrel lengths are from the end of the threads to the tip.

Here is the list from top to bottom.

7mm 19" - it had a tag on it when I purchased that listed it as a Battue but I do not one to compare it to. Front and rear sights have been removed. Slight marks from removal. No import marks. Caliber markings on side of barrel.

7mm 24 1/4" - No factory sights installed and no import marks. Caliber markings on top of barrel.

30-06 23 9/16" - Factory sights removed. Appears to be shortened. Caliber markings on top of barrel

30-06 24 1/4" - Bofors Factory front sight sweated off. Slight pitting on front of barrel but would cover by the stock.

308 22 9/16" - Front sight installed. Caliber markings on top of barrel.

243 22 3/8" - Stoeger Import Marks. Caliber markings on side of barrel.

IMG_03061_zpsg1jfxt3l.jpg

IMG_03071_zpsh6ufm2rp.jpg
 
Back
Top